How to set up an iCT250 from Global Payments

How To

How do set up Global Payments iCT250?

Follow these steps

From the pin pad, follow these steps.

Get the current IP

  • Prompt: welcome/bonjour
  • Press #
  • Enter admin name
  • Press 1, enter
  • Enter admin password (F to get letters)
  • Press Enter
  • Admin menu
  • Press 3 for setup
  • Setup menu
  • Press 2 for communications
  • Communications
  • Press 3 for ethernet
  • Press 1 for current setup
  • Confirm IP Type: Static

If dynamic, note down the address details:

IP Address: 192.168.1.244.  192.168.20.103 

Gateway IP: 192.168.1.1.  192.168.20.1

Subnet mask: 255.255.255.0. 

Pri DNS: 8.8.8.8

Sec DNS: 8.8.4.4

Press red button 4 times until you get to admin menu

 

Setup static IP

  • Admin menu
  • Press 3 for setup
  • Setup menu
  • Press 2 for communications
  • Communications
  • Press 3 for Ethernet
  • Ethernet menu
  • Press 2 for Ethernet setup
  • Ethernet setup
  • Press 2 for static iP
  • Press 1 for terminal IP
  • Press yellow to clear
  • 192 # 168 # 1 # 244
  • Press Enter
  • Press 2 for gateway IP
  • Yellow to clear
  • 192 # 168 # 1 # 1
  • Press Enter
  • Press 3 for subnet mask
  • Yellow to clear
  • 255 # 255 # 255 # 0
  • Press Enter
  • Press 4 for pri dns
  • Yellow to clear
  • 8 # 8 # 8 # 8
  • Press Enter
  • Press 5 for sec dns
  • Yellow to clear
  • 4 # 4 #4 # 4
  • Press Enter

(host port 1 & 2 - 443)

Press red button 4 times

Terminal will reboot

———

Setup receipt printing

  • Prompt: welcome/bonjour
  • Press #
  • Enter admin name
  • Press 1, enter
  • Enter admin password (F for letters)
  • Press Enter
  • Admin menu
  • Press 9 for Misc Options
  • Misc Options
  • Press 1 for Semi Integrated
  • Semi integrated
  • Press 1 for enable semi integ
  • Press On
  • Semi integrated
  • Press 2 for Communication Type
  • Semi Integrated
  • Press 3 for Ethernet
  • Enter 9000 for port of it 9000 is already there press enter
  • Semi Integrated
  • Press 3 for receipt options
  • Receipt options
  • 1 for ECR, 2 for terminal, 3 both
  • Press red key 3 times to go to admin menu (4 for welcome/bonjour)
Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.